MIMAKI CJV30 Series, Руководство по обслуживанию

Страница: 102 / 316

© 2009 MIMAKI ENGINEERING CO.,LTD. 4.2.6 P.1
1
2
3
4
5
6
7
8
R.1.1
Maintenance Manual > Adjustment Items > Adjustment Function > HEAD ID
Model CJV30/TPC Issued 2008.08.04 Revised 2009.06.30 F/W ver. 1.00 Remark
1.1
Rev.
4.2.6 HEAD ID
 Function
Head ID input of this machine is automatically executed by the printer side.
The head memory PCB assy is mounted on the head unit assy, and the ID information is written in the head memory
PCB assy.
 Procedure (In case of manual input)
1. Prepare a head ID.
2. Select [HEAD ID] from the operation menu.
3. Enter the head ID.
[ENTER]: Determines and saves.
Head ID is for compensating differences of discharge amount of ink among each head. A label on which a
compensation value (ID: in 24 digits) is written is attached on a head at the factory shipment.
Storing this ID in the Parameter of this machine makes print quality constant.
Manual input of the ID information is required in the following cases.
 In a case that the ID information is not stored in the head memory PCB assy:
[HEAD ID Un input] is displayed on the panel (at power on)
 Pay attention when replacing PCB, because even if the head ID is not identical to the ID information in
the memory PCB assy (a PCB of another head is placed, for example), the error is not displayed on the panel.
Manual input of ID is recommended if there is a doubt on the agreement between the ID of a head and the
ID information in the memory PCB assy.
Head ID (24 digits)
<LOCAL.

> [#01]
FUNCTION
#ADJUST <ent>
#ADJUST / PRINT
HEAD ID <ent>
#HEAD ID /

 
If the ID, which has been input, is incorrect, operation
error (ERROR 30) is displayed.