MIMAKI CG-100EX, Руководство по эксплуатации

Страница: 63 / 110

– 3.13 –
No. of copies [No. COPIES]
This function is used to perform cutting (plotting) of the received data on two or more sheets.
The device stores the received data in the receiver buffer to enable cutting (plotting) in repetition on
as many as 999 sheets.
When the device receives new data, the data stored in the receiver buffer will be updated.
Setting value (input of numeric data)
1 to 999 (sheets)
* If the plural sheet cutting is executed immediately after cutting under the remote
mode, the data will be cut (plotted) overlapped. To avoid this trouble, re-set an
origin.
* While the device is executing the plural sheet cutting, it ignores data sent from
the host computer. To send plural pieces of data from the host computer to the
device, the data has to be sent while providing an interval of 10 seconds or more
between any two pieces of data. If two pieces of data are sent from the host
computer to the device within 10 seconds, the two pieces of data will be subjected
to the plural sheet cutting.
* If the origin updated inside the device during setting up the two-point axis
alignment fails to fall within the effective cutting area, the device will not cut the
data.
* The device cuts divided cut data by the specified number of sheets without dividing
the data.
* In the event that any error appears on the LCD, refer to Chapter 4.
A
B
The locations of copies for second cutting
(plotting) and beyond are to be allocated
according to the size of the original data.
Lengthwise and widthwise interval between
copies of the original data is 1 mm.
After the completion of copying, the location
of origin will be updated.
Original data
The origin at the time of
executing the plural sheet
cutting.
The origin at the time of
terminating the plural
sheet cutting (automatically
established)