MIMAKI CG-100AR, Руководство по эксплуатации

Страница: 59 / 184

Chapter 2 Cutting
59
2.3 Installing Tools
This machine can be used with the following tools:
• Cutter (for cutting)
Used to cut the printed image on a sheet or to cut characters with the cutting sheet.
"Using the Cutter"(P. 59)
• Pen (water-based ballpoint pen)
Used for test printing or to adjust register marks. This machine can be used with a ballpoint pen or
cartridge refill.
"Using a Pen"(P. 63)
• Creasing tool
Used for creasing coated card.
"Using the Creasing Tool"(P. 67)
Using the Cutter
Installing the Cutter in the Cutter Holder
Be careful to keep the cutter from falling into a gap in this machine. We recommend replacing the cutter over
the sheet to enable the cutter blade to be picked up easily if it falls.
• Avoid touching the cutter blade. Failure to do so may result in injury.
• Do not shake or swing the cutter holder. Doing so may cause the blade to come off.
• Avoid storing this product in locations accessible to children.
• When disposing of cutters, contact an industrial waste disposal operator or dispose in
accordance with the local laws and regulations.
1
Insert the cutter into the cutter holder using tweezers.
• Check the orientation of the cutter before inserting it fully.
• For information on blade replacement, refer to "Cutter Replacement"(P. 147) .
Adjusting the Cutting Blade Protrusion Length
Adjust the cutting blade protrusion length (0.2 to 0.5 mm) to suit the cutter and sheet type being used.
• If the base paper is thicker than the label film: (label film thi base paper thickness)/2
Label film
Base paper
Cutting blade
protrusion length
Cut amount
2