Milwaukee M18 CHD-0, Руководство оператора

Страница: 6 / 8

6
WARNING
To reduce the risk of personal in-
jury and damage, never immerse
your tool, battery pack or charger in liquid or
allow a liquid to flow inside them.
Cleaning
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
Repairs
For repairs, return the tool, battery pack and charger
to the nearest service center.
ACCESSORIES
WARNING
Use only recommended accesso-
ries. Others may be hazardous.
To reduce the risk of injury, always
unplug the charger and remove the
battery pack from the charger or tool before
performing any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
MILWAUKEE
®
service facility for ALL repairs.
Maintaining Tool
-
7. To remove the anchor head wedged in the tooth
anchor chuck, use a drift pin.
8. To remove the tooth anchor chuck, remove the
“B” taper adapter from the nose of the tool. Insert
the drift pin supplied with the adapter into the hole
on the side of the “B” taper adapter and strike it
sharply to force out the tooth anchor chuck.
6. Snap the head off of the anchor. To remove the
head of anchors up to 16 mm (5/8"), grasp the
handles firmly and pull the tool sharply towards you
or snap off the anchor head with a hand hammer as
shown. The anchor is now ready to receive a bolt.
MILWAUKEE
®
Rotary Hammers may be used for
chipping and chiseling. A variety of accessories are
available. When chiseling, hold the tool at an angle
to the workpiece. Work from a corner or close to the
edge of the workpiece, breaking off one small area
at a time rather than attempting too large an area.
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
®
service facility for repair.
After six months to one year, depending on use,
return the tool, battery pack and charger to a
MILWAUKEE
®
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE
®
service facility for repairs.
Chiseling and Chipping
MAINTENANCE
WARNING
For a complete listing of accessories refer to your
MILWAUKEE
®
accessories catalogue or go online
to www.milwaukeetools.com.au or
www.milwaukeetools.co.nz. To obtain a catalogue,
contact the store where the product was originally
purchased or one of our authorised MILWAUKEE
®
service centres.