5
SYMBOLOGY
CAUTION! WARNING! DANGER!
Please read the instructions carefully before
starting the machine.
Always wear goggles when using the
machine.
Wear gloves!
Always disconnect the plug from the socket
before carrying out any work on the machine.
Do not use force.
Only for cutting work.
Only for grinding.
Accessory - Not included in standard equip-
ment, available as an accessory.
Do not dispose of electric tools together with
household waste material. Electric tools and
electronic equipment that have reached the
end of their life must be collected separately
and returned to an environmentally
compatible recycling facility. Check with your
local authority or retailer for recycling advice
and collection point.
Class II tool Tool in which protection against
electric shock does not rely on basic
insulation only, but in which additional safety
precautions, such as double insulation or
reinforced insulation, are provided. There
being no provision for protective earthing or
reliance upon installation conditions.
Regulatory Compliance mark (RCM). This
product meets applicable regulatory
requirements.
ASSEMBLY
WARNING
To reduce the risk of injury, always
unplug tool before changing or
removing accessories.
Removing/Installing/Adjusting the Guard
This tool is shipped with a guard. The guard must be
used when using the tool as a grinder. The guard
may be removed when using tool as a sander.
1. To remove the guard, unplug tool and remove any
accessories from spindle.
2. Press in the detent tab and rotate the guard
clock-wise until the tabs on the grinder line up with
the slots in the guard.
3. Lift the guard straight up and away from the tool.
4. To
install
the guard, unplug the tool and remove
any accessories from the spindle.
5. Line up the tabs on the grinder with the slots in
the guard. The arrows on the grinder and guard will
align.
6. Press in the detent tab and press the guard onto
the tool. Rotate guard counterclockwise into first
detent slot.
7. To
adjust
the guard, press in the detent tab and
rotate the guard to one of five detent slots.
WARNING!
Always adjust the guard to provide the
operator with maximum protection while operating.
Operator's Zones
WARNING
To reduce the risk of injury, always
use a side handle when using this
tool. Hold securely.
Installing Side Handle
The side handle may be installed on either side of
the gear case. Position the side handle in the
location which offers best control and guard protec-
tion. To install, thread side handle into side handle
socket and tighten securely.
WARNING
To reduce the risk of injury, the
operator should be instructed in
the use, care and protection of grinding wheels.
Use the cutting guard (not included) for cutting
application.
