Milnor MILRAIL, Установка, запасные части и обслуживание

Страница: 14 / 68

12
Pellerin Milnor Corporation
3. Apply a spray of LocTite 7649 Primer TM or equal on the fasteners and the mating threads. Let
the primer dry for one minute minimum.
1.2.3 How to Apply a Threadlocker
BNUUUN02.T02 0000222508 A.3 B.2 B.3 11/26/19 2:48 PM Released
CAUTION:
Malfunction Hazard — Heat, vibration, or mechanical shocks can let the
fasteners loosen if you do not apply the threadlocker correctly. Loose fas-
teners can cause malfunctions of the equipment.
�
Read the threadlocker manufacturer's instructions and warnings. Obey these
instructions.
Apply the threadlocker only to the areas where the fastener threads and the mating threads
engage.
Figure 2. Apply Threadlocker in a Blind Hole
Application Coverage
Legend
A... No threadlocker here
B... Apply here
C... Fill all space with threadlocker
1.2.3.1 Blind Holes
BNUUUN02.T03 0000222507 A.3 B.2 B.3 1/2/20 2:14 PM Released
1. Apply the threadlocker down the threads to the bottom of the hole.
2. Apply the threadlocker to the bolt.
3. Tighten the bolt to the value shown in the correct table ( Threadlocker by the Diameter of the
Bolt (see below Note ) This topic can be found in Milnor document elsewhere to Torque Val-
ues for Stainless Steel Fasteners 5/16-inch and Smaller This topic can be found in Milnor
document elsewhere
).
1.2.3.2 Through Holes
BNUUUN02.T04 0000222506 A.3 B.2 B.3 11/26/19 2:51 PM Released
1. Put the bolt through the assembly.
2. Apply the threadlocker only to the bolt thread area that will engage the nut.
General Service Information