Milnor 76028 CBW, Схемы/Электрические компоненты

Страница: 54 / 299

PELLERIN MILNOR CORPORATION
3.2.3.1.
Example: “Early Call” Output
—An output assigned to the last CBW module must be defined
to provide the signal needed by two load interface operational inputs on the Milnor extractor. It is
permissible to trigger these inputs simultaneously, (thus requiring only one programmable output
on the CBW, not two). The extractor inputs include:
• “early call / end extract”
• “loading mode / start extractor”
On the left side of the Mentor Function Programming Page , define the function properties for the
early call
output as follows:
• Function name: “Early Call”
• C (Compatibility) = 0
• H (Hold Code) = not checked
• Op Code = 09 (“Early Call”)
• S (Show on formula programming page) = checked
On the right side of the Mentor Function Programming Page , the programmable output will be
represented in the Bit and Init columns for the last module. Define the module-specific properties
as follows:
• Bit = the identifier number for this output (see Section 3.2.1.2 “Relating the Output to the Bit
Number”).
• Init = A
On the Formula Programming Page , assign
On Time
= 255 for every formula (see Note 2).
Note 2:
The extractor load scoop must be lowered (or the door raised) even in the case of the
pass empty
formula, or the extractor will not signal that it is OK for the CBW to transfer (extractor load interface
operational output “load allowed / start discharge”).
3.2.3.2.
Example: “Start Extract Cycle” Output
—An output assigned to the last CBW module must
be defined to provide the signal needed by the “transfer complete / start cycle” input on the
extractor that raises the load scoop (or lowers the door) and starts the extract cycle. On the left
side of the Mentor
Function Programming Page , define the function properties as follows:
• Function name: “Start Extract Cycle”
• C (Compatibility) = 0
• H (Hold Code) = not checked
• Op Code = 00 (“Standard Timed”)
• S (Show on formula programming page) = checked
On the right side of the Mentor Function Programming Page , the programmable output will be
represented in the Bit and Init columns for the last module. Define the module-specific properties
as follows:
• Bit = the identifier number for this output (see Section 3.2.1.2 “Relating the Output to the Bit
Number”).
• Init = H
On the Formula Programming Page , assign
On Time
= 004 for every formula (see Note 2).
3.2.3.3.
Example: “Extractor Free” Input (G3 CBW)
—The CBW needs a signal to indicate when
the extractor is free to receive a load. This is provided by the “load allowed / extractor says load
allowed” output signal on the extractor. On the 76032 CBW, an explicit “press free” input is
provided. But on the G3 CBW, a special input must be defined to read this signal. On the Mentor
48