Milnor 36026X8R, Руководство по обслуживанию

Страница: 27 / 177

Chapter 3. Routine Maintenance
PELLERIN MILNOR CORPORATION
Table 5: Bearings and Bushings. See Table 6 for Motors.
Apply grease to these components to prevent damage.
Mark
1 2 3 4 5 6
Do this each Component
More Data. See also Section 3.1.4
“Lubricant Identification and Procedures”
Grease plate 01 10025Z for bearing housing. See Figure 14 and Section 3.1.4.2 .
x 200 hours seal Add 0.06 oz. (1.8 mL) of grease EPLF2
(
Table 9 )
x 200 hours rear bearing Add 0.12 oz. (3.6 mL) of grease EPLF2
x 200 hours front bearing Add 0.12 oz. (3.6 mL) of grease EPLF2
Other Grease Ports
x 200 hours ball bushings on suspension
shafts See Figure 15 . Add 0.06 oz. (1.8 mL) of
grease EPLF2 ( Table 9 ).
Table 6: Motor Grease Schedule. Use the data in Section 3.1.4.3 to complete this table.
Interval Quantity Dates When Grease is Added
Motor Identification
(example: main drive)
Years Hours fl oz mL
.
Table 7: Mechanisms and Settings
Make sure mechanisms are serviceable and settings are correct to prevent unsatisfactory
performance.
Mark
1 2 3 4 5 6
Do this each Component More Data
x 2400 hours controller circuitry Examine wiring and connections in electrical
boxes. Look for corrosion, loose connections.
See
Section 3.1.3
x 200 hours water pressure regulator for
optional supply injector See Figure 10 . Value: 28 PSI (193 kPa).
x 200 hours bath level sensor that uses air
pressure Examine the air tube and connections. See
Figure 11
23