7 of 32
Locate your z screw seat plate and UHMW screw seat. Place the UHMW
screw seat on top of the screw seat plate. Make sure the pocket of the
UHMW screw seat is facing up as shown.
Secure the UHMW screw seat to the screw seat plate using (2) M5x16
Machine screws and (2) M5 nylock nuts. Do not over tighten or you may
deform the UHMW screw seat.
The front of the X Plate is the face with the recessed pockets. The top of the
X Plate
is the section with the “U” cutout, as shown
above. Place the screw
seat plate on the X Plate near the bottom, center set of holes. Make sure the
UHMW screw seat is pointing towards the top of the X Plate. Place a M4
split lock washer on (2) M4x12 machine screw and insert the screws through
the back of the X Plate to secure the screw seat plate to the X Plate.
Place the Z Plate on the front of the X Plate. Line up the holes on the z rails
with the (3) holes on each side of the X Plate. (2) holes on the top on each
side and (1) hole on the bottom on each side. Carefully remove the top
bearing block or tape on both rails. Insert a M3x16 machine screw in the top
hole on both rails and finger tighten a M3 nylock. Repeat the process with
the second set. Carefully remove the bearing block or tape from the bottom
of the z rails. Insert a M3x16 machine screw in the bottom hole on both rails
and finger tighten a M3 nylock.
Prop the X Plate on its bottom using the router mount. Place eccentric
spacers in the top, large holes on the back of the X Plate. Insert M8x40
machine screws into the large holes in the front of the X Plate and through
the eccentric spacers. Place an assembled v-wheels on the M8x40 machine
screw and secure with a M8 nylock nut.
