Miller OM-246 466B, Руководство пользователя

Страница: 33 / 76

OM-246 466 Page 29
4-5. PipePro 300 Set Up For MIG (GMAW) Equipment
See Table 4-1 for selection choices.
1. Turn welding power source Power switch on (approximately 30 seconds for complete operation). Push Program
button. Use the Adjust knob to choose a desired program number from the 1 through 8 selection.
.
If the desired program has been previously loaded, only the program number needs to be selected. This process does not have to be followed
every time a different program is selected.
2. Push Setup button once. Use the Adjust knob to choose weld Process (MIG, Pro-Pulse, RMD-Pro, FCAW).
.
FCAW has no wire settings, but does have a gas setting, go to Step 6.
3. Push Setup button again. Use the Adjust knob to choose Wire Type (INCO, MCOR, CrMo, SS, or STL).
4. Push Setup button again. Use the Adjust knob to choose Alloy Type (filler metal classification).
5. Push Setup button again. Use the Adjust knob to choose Wire Diameter.
.
MIG has no gas options, go to Step7.
6. Push Setup button again. Use the Adjust knob to choose Gas Mixture. For FCAW, choose “YES” or “NO”.
7. Push Setup button again. The display will read PROG LOAD and welding power source is now ready for the
welding operation.
.
No changes are saved until PROG LOAD appears on the display after completing the settings. If the Setup button is pressed to review the settings
and nothing is changed, PROG LOAD will not appear on the display for the program that was just loaded.
200 410