Miller Easy Lift Harness
Disconnecting the leg buckles
© ⅯⅯⅩⅡ Miller Diving. All rights reserved. Document # 120613010
7
Bring the
strap up through #2
slotted hole
Push the strap
down through #1
slotted hole
Tighten strap
and tuck the
loose end into the
adjustment sleeve
B
CAUTION
The male buckle must be inserted in the correct direction
into the female buckle, failure to do so will result in the
inability to interlock the two buckles.
Inserting the leg buckles
Wrap leg strap and buckle around the leg, back to front. Push the
male buckle up through the female buckle and lock it.
Incorrect male buckle direction
Correct male buckle direction
✓
The leg straps should fit comfortably snug. Adjust these straps
as necessary.
Push the male buckle up through
the female buckle
Lock buckles together
Disconnecting the leg buckles
To disconnect buckle, tilt the male end towards the rivets on the
female side of the buckle. Fit it into the female slot and push
buckle through. This will release the leg strap.
Maintenance of the Miller Easy Lift Harness
The Easy Lift harness is made using high tensile strength nylon
webbing and heavy duty stainless buckles and D-rings thereby
minimizing maintenance. However, it is essential to thoroughly
inspect the harness for damage and wear before and after each
dive. DO NOT USE the harness if its serviceability has been
compromised or if there is any doubt about its serviceability.
Wash the harness in clean fresh water after each use and hang
or lay out to dry in a clean dry shaded area out of direct sunlight.
If the harness has been exposed to any pollutants thoroughly clean
with warm soapy water and rinse thoroughly before storing. Do
not use bleach or any harsh chemicals on the harness.
B
WARNING
DO NOT USE the harness in polluted water. Failure to fol-
low this instruction may result in equipment failure and
serious injury.
