OM-1572 Page 4
B. Installing Torch In Inverter Power Source
ST-128 701-C
1
2
3
4
S-137 691
Label is located under
terminal strip.
7
8
9
6
Turn Off power source, and
disconnect input power plug. Open
lower front access door.
1
Access Door
2
Strain Relief Clamp
3
Torch Cable
4
Torch (–) And Air/Gas Output
Connector
Connect torch cable as shown.
5
Terminal Strip1T
6
Connection Label
7
Pilot Arc/Shield Cup Detector
Lead 1
8
Shield Cup Detector Lead 2
9
Torch Switch Leads 3 And 4
Refer to label and connect leads as
shown.
Install strain relief clamp, and close
access door.
10 Work Cable (Supplied With
Power Source)
5/8 in
Tools Needed:
1
5
3
4
2
10
Figure 3-3. Installing Torch In Inverter Power Source
SECTION 4 – OPERATING THE TORCH
ELECTRIC SHOCK can kill.
•
Always wear dry insulating gloves.
•
Insulate yourself from work and ground.
•
Do not touch live electrical parts.
•
Keep all panels and covers securely in place.
FUMES AND GASES can be hazardous
to your health.
•
Keep your head out of the fumes.
•
Ventilate area, or use breathing device.
•
Read Material Safety Data Sheets (MSDSs) and
manufacturer’s instructions for material cut.
CUTTING can cause fire or explosion.
•
Do not cut near flammable material.
•
Provide protection from flying sparks.
•
Watch for fire; keep extinguisher nearby.
•
Do not locate unit over combustible surfaces.
•
Do not cut on closed containers.
•
Allow work and equipment to cool before handling.
ARC RAYS can burn eyes and skin;
NOISE can damage hearing.
•
Wear face protection with correct shade of filter.
•
Wear correct eye, ear, and body protection.
MOVING PARTS can cause injury.
•
Keep away from moving parts.
•
Keep all doors, panels, covers, and guards closed
and securely in place.
See Safety Precautions at beginning of manual for ba-
sic cutting safety information.
WARNING
swarn6.1* 10/91
