www.milleredge.com [email protected] 800-220-3343
4/4
GENERAL SPECIFICATIONS
Length
Per spec to +/- .25” or 6 mm
Lead Wire
2 ft. length of 18 or 22 gauge SJTO
Sensitivity
Nominal 6-11 lbf
Electrical Maximum
24 VAC/DC, 1/2 amp
Contact Element
Alumaglas®
Materials
Extruded flexible PVC
Temperature Rating
-30°F to +155°F or -34°C to +68°C
Warranty
1 year
Ratings
UL 325 Recognized Component
ELECTRICAL CONFIGURATION OPTIONS
• 2-Wire 8.2K Ohm Resistive (T1/green band)
• 2-Wire 10K Ohm Resistive (T2/blue band)
• 2-Wire Diode Capacitor (T3/red band)
• 2-Wire Capacitor (T4/white band)
• 2-Wire 6.8K Ohm Resistive (T5/orange band)
• 2-Wire 270K Ohm Resistive (T6/violet band)
• 2-Wire Non-Monitored
• 4-Wire Monitored
• Bumper (no sensor)
MAINTENANCE
It is strongly recommended that end users test the Sensing Edge at least once per month. Check the Sensing Edge for cuts, loss of sensitivity, or water
damage. Also check for signs of damage to cables or connection points. Starting 2” from the ends, compress the Sensing Edge 1/2” throughout the
length of the edge and observe that it sends an electric signal to the controls.
REPLACEMENT
To replace your Miller Edge Sensing Edge, contact your Miller Edge sales representative. Attempt to repair your Miller Edge sensing edge is not
recommended and will void the manufacturer warranty.
WARRANTY
Miller Edge, Inc. will replace within one year of shipment from factory any Sensing Edge subject to normal use, which is found to have defective
materials or workmanship, as determined solely by our factory representative. Replacements will be shipped to you freight collect. This warranty is
void where evidence of misuse or abuse is present.
ACCESSORIES
Contact your Miller Edge sales representative for sensing edge accessories:
MOUNTING CHANNELS
JUNCTION BOXES
COIL CORDS
RETRACTING REELS
TRANSMITTERS/
RECEIVERS
MODULES
ME123 SENSING EDGE
