10
BEAD
RECEIVER
DUCT TAPE
BEAD
RECEIVER
LINER
LINER
BEAD
WALL
FIGURE 18
W00023
WARNING:
The pool must not be more than 3/4” out of level. If the
pool is not level, drain the water and level the structure. Any non-
compliance with this requirement will void all warranties.
Step 20:
See Figure 19, 20, 21 and 22. Locate the safety warning copings as described and as shown at the back of
this manual. Attach all coping as shown.
Step 21:
S ee Fig ure 23 A and 2 3B. Assemble th e co ping covers a s sho wn ba sed on t he type of p ool you are
installing.
#10 x ½” SELF
TAPPING HEX
HEADSCREWS
(4 PER TOP CLIP)
#10 x ½” SELF
TAPPING HEX
HEAD SCREWS
ROUND END COPING
UPRIGHT
SLAT
TOP CLIP
FIGURE 20
W00053
FIGURE 19
CO00021A
Step 16:
Se e Figu re 1 8. Remove the liner from th e ca rton and unfold into t he po ol. Be ca reful not t o dra g,
abrade o r sn ag the line r. Spread th e liner o ut over t he entire b ottom of the pool. The lin er bottom should b e
centered in the pool using the seam at the perimete r of the bottom as a guide . Locate the triangle shaped tabs
on the u nderside of the li ner. Th ese tabs should be lined up with the four t ransition uprights on the flo or of the
pool. Raise the liner sidewall and place the bead into the bead receiver. Bead must be fully seated in the receiver
to prevent it from coming out later when filling. Check frequently while filling pool with water.
Step 17:
S mooth all th e wri nkles out on the bo ttom of the liner. To
remove wrinkles, always pull the liner firmly but gently. No sharp tugs! Be
certain line r is ce ntered. Time sp ent removing wrin kles and ali gning the
liner will give you a neater looking and easily maintained pool.
Step 18:
Begin to fill the pool with water. Use a slow stream of water and
fill approximately 1 1/2” deep. Be certai n that the blocks un der the bottom
beams have remained level and that the bottom bea ms are seate d firmly
on those blocks. Make sure the fit of th e liner is correct. Smooth out any
wrinkles in th e pool botto m. Remove the con struction nuts a s previously
shown in figu re 9.
If installing a deck, do not fill more than 12” until
the deck is installed.
Step 19:
Fill the p ool with 4” to 6” of water. Me asure the distance from
the bead receiver to the water surface at several points around the pool to
be certain that the pool is still level.
NOTE:
If the liner i s exposed to the sun for a long time, it will stretch and cause wrinkles. This can be
avoided by waiting until dusk or by spraying cold water on the liner during installation.
ATTACH COPING
TO
OUTER
SET
OF TOP CLIP
HOLES ON THE
ROUND ENDS
