3262019
6
M-250-00/M-251-00 CLIMBING SYSTEM COMPONENTS
FIGURE 1
Components of M-250-00/M-251-00 Climbing System
(4) 32-Inch Climbing System Section(s) (one shown)
(2) Tree Brace(s)
Cam Buckle Strap Hooks
(4) Cam Buckle Strap(s) (one shown)
M-250-00/M-251-00 CLIMBING SYSTEM ASSEMBLY
WARNING! These Millennium product(s) were designed for installation on trees with a
minimum diameter of 12-inches (30cm) at treestand installation height (i.e., seat height)
and a maximum treestand installation diameter of 20-inches (51cm). DO NOT use your Mil-
lennium product(s) on trees with trunk diameters that do not meet this minimum diameter
requirement. Failure to follow these instructions may result in serious injury or death!
STEP 1: To install your M-250-00/M-251-00 Climbing System, you must first install the cam buckle
straps onto the climbing system sections prior to installing them onto a tree. For ease of climbing
system installation, if you are right-handed, it is recommended that you install the cam buckle
strap onto the left cam buckle strap hooks on the climbing system sections. If you are left-handed,
it is recommended that you install the cam buckle strap onto the right cam buckle strap hooks on
the climbing system section.
STEP 2: To install the cam buckle strap, slip one of the loop ends on the cam buckle strap over
the cam buckle strap hook as shown in Figure 2. NOTE: These attachment hooks were designed
to hold the cam buckle strap secure. Repeat this STEP for the four (4) climbing system sections.
You are now ready to install the climbing system sections onto the tree.
1
3
2
FIGURE 2
INSTALL CAM BUCKLE STRAP LOOP END
ON CAM BUCKLE STRAP HOOKS
2
4
4
2
3
1
