MILL TG10B, Сборка и инструкция по эксплуатации

Страница: 12 / 14

The unit is not working
The product is not receiving power Connect the plug to the socket and check
The product is not switched on Turn on the product
The light indicating full water tank
is lit If the water tank is full, please empty the tank. The
product will restart when the tank is re
- inserted.
Operating time is too short Please leave the product on for a longer period
Dehumidifying capacity is low
Air filter is dirty or blocked Wash the filter or remove what is blocking it
Temperature or humidity is too
low
Dehumidifying capacity becomes lower as the tem-
perature drops. Please increase the room temper-
ature for better capacity.
Desired humidity level is set higher
than the detected humidity in the
room
Set the desired humidity level lower than detected
humidity level
Drainage tube (in continuous op-
eration) is blocked or flat Check the drainage tube and replace it if necessary
Make sure that the tube has a sufficient drop.
Desired humidity lever is not
reached after long operation time
Open windows or doors
Shut windows and doors so that the room is not
affected by other humidity levels
Water on the floor The product has been pushed or
moved and water from the water
tank has splashed out
Air from the air outlet is hot Heat exchange process
Sound from the product Cooling liquid that passes through
the compressor/compressor is
working
Troubleshooting
Please go through the troubleshooting guide to identify what can be done to correct the problem.
Contact Mill International AS should the problem persist
EN 12 millclimate.com