LOOX EYE-CONTROL FOR MACROPATH
MM171-001
–Operator Manual
11
1.6 Waste disposal of the equipment
It is recommended to use alcohol-based rapid disinfectant for non-invasive medical products.
For further information, contact [email protected]
Complying with directive 2012/19/EC of the European Parliament and of the Council of 4 July 2012 on waste
electrical and electronic equipment (WEEE), the separate collection environmental managed of equipment is
mandatory.
It is necessary to return the used equipment to the distributor or to inquire about the presence of a local
empowered system for collection and disposal of WEEE.
The in-observance of Directive 2012/19/EC or of the local law which acknowledge it can have potential effects
on the environment and human health.
This symbol indicates separate collection
for electrical and electronic equipment
If additional requirements on accident prevention and environmental protection exist in the country of
operation, this instruction manual must be supplemented by appropriate instructions to ensure compliance to
such requirements.
1.7 Return for repair to manufacturer
This instrument is not an in-vitro medical diagnostic device and it is usually installed in a laboratory where
samples and other biological tissues are present. For your safety, it must therefore be cleaned and disinfected
before use, and gloves must be worn when touching this instrument.
If the unit needs to be returned to Milestone s.r.l. for repairs, the device must be cleaned up and disinfected
prior to shipment. See chapter 5. Any units that have not been disinfected will not be accepted and you will be
contacted with regards to disinfection cost. In accordance with international health standards, biohazard
materials must be shipped in appropriate packages disinfected (risk of fines).
Do not dispose LOOX Eye-Control in general household or office waste. Follow your local
regulations for the disposal of electrical and electronic equipment.
Before doing any operation disconnect the power supply.
Do not use direct or high-pressure water to clean the instrument.
For safety reason, any operation without the individual protective devices must be avoided.
