Milennia MIL-AMP200BT, Руководство по эксплуатации

Страница: 2 / 5

CONNECTING THE POWER
RCA INPUT AND HIGH INPUT INPUT
SENSITIVITY: 250mV-6V
LPF/FULL/HPF SELECTION SWITCH
CAUTION
AS A PRECAUTION, IT IS ADVISABLE TO DISCONNECT THE VEHICLE
＇
S BATTERY BEFORE MAKING CONNECTION TO THE
+ 12 VOLT SUPPLY WIRNG(Fig .1)
10 GAUGE (or a large guage of wire if planning for additional Amplifiers )wire is
recommended for the power and ground wires. 20 Gauge, for the remote
turn-on wire. Both types are available at most Mobile Audio Dealers or Installation
Shops.
GROUND:
To Vehicle Chassis
To avoid unwanted ignition noise caused by ground loops, it is essential that the
Amplifier be grounded to a clean, bare,metal surface of the vehicle
＇
s chassis.
NOTE
GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3 FT. ( 1 METER).
USING THIS METHOD CAN CAUSE TURN ON AND TURN OFF TRANSIENTS (NOISE)
+12 Volt(Fused) Constant Power: To Battery (+)
Due to the power requirements of the Amplifier, this connection should be made
directly to the positive (+) terminal of battery. For safety measures, install an in-line
50 Amp Fuse Holder (not included) as close to the battery Positive (+) terminal as
possible.
With an ampere rating not to exceed the total value of fuses in amp.
Remote Turn-On Input:
To Power Antenna output of Vehicle Stereo
This Amplifier is turned
＂
ON
＂
remotely when the vehicle
＇
s stereo is turned
＂
ON
＂
.
NOTE
IF YOUR RADIO DOES NOT HAVE A +12 VOLT OUTPUT LEAD WHEN THE RADIO IS TURNED ON,
＂
RMT
＂
TERMINAL ON
THE AMPLIFIER CAN BE CONNECTED TO VEHICLE
＇
S ACCESSORY CIRCUIT THAT IS LIVE WHEN THE KEY IS
＂
ON
＂
.
Chassis
Ground
Chassis
Ground
Remote Turn ON
To Power Antenna
FUSE Holder
Near Battery
+
-
BATTERY
1
2
MIL-AMP200BT
4 Channel
N/A
N/A
4 x 20W
250mv - 6V Low Level
N/A
N/A
N/A
N/A
N/A
N/A
40
105
130