WINCH OPERATIONS
Function Testing
After checking all connections in accordance to installation instructions prior, connect power cables to vehicle’s battery. Attach black cable to
negative (-) battery terminal and secure, followed by attaching the red cable to positive (+) battery terminal.
1. Before testing the winch, turn the clutch handle to the Disengaed position. Always wear heavy gloves when handling winch cable.
Using a Mile Marker hand saving belt, pull about two feet of cable off the winch drum, and place the clutch handle in the Engaged
postion (Fig. 3.1).
2. Push the IN button to retrieve line (Fig. 3.2). Winch cable will spool in on drum.
3. Push the OUT button to power out winch cable (Fig. 3.2). Winch cable will spool out off of drum.
4. If any of the above functions are not working properly, recheck all connections in accordance with installation section of this manual, or
refer to troubleshooting section in back of manual.
NOTE:
If cable is spooled Out while pressing the IN function, please refer to Fig. 3.1 and switch power cables to
opposite studs on motor.
NOTE:
The OUT function is for INTERMITTENT USE ONLY, as you are powering drum against the brake, and can damage
internal mechanism.
Fig. 3.1
Fig. 3.2
2121 Blount Road Pompano Beach, FL 33069 MileMarker.com 1.800.886.8647
PAGE 7
Wireless Remote Control Operation
Activate the remote by pressing the On/Off button for 3 seconds until the LED lights up.
Press OUT or IN to operate winch
To turn off the remote, keep pressing the On/Off button for 3 seconds until LED turns off. The remote will
automatically power off. The remote will automatically power off in 2 minutes if its not used.
CAUTION:
Only operate the winch while the winch, line, and load are in view. Make sure
that there are no bystanders nearby.
1.
2.
3.
Engaged
Disengaged
Make sure
winch lever is
fully engaged
