5
3. Installation
To install the MIL-L100s Power over Ethernet Splitter, please follow the steps
below:
0. Using RJ-45 cable that is
Data in
port on the Power over Ethernet Splitter
to connect with the PoE Switch/HUB (which is
Data out
port). If the
Switch/HUB does not support PoE function, you need to install a PoE
injector between Switch/HUB and Power over Ethernet Splitter.
0. Using RJ-45 cable that is on the
Data out
port in Power over Ethernet
Splitter to connect with the PD (Such as Router, Access Point…etc.)
0. Plug in the power cable of the Power over Ethernet Splitter to the PD’s
power plug.
0. Adjust the Voltage for PD; switch the DIP setting on the Power over
Ethernet Splitter. It supports two type of voltage – 12V or 5V.
The default
value will be set on 5V
. When you change voltage by DIP switching to
12V, the Power over Ethernet Splitter must be in powered off status.
0. Before starting, make sure all connections are correct and the voltage is
right.
The Power over Ethernet Splitter connects to the Switch or POE
Hub is in
Data in
port.
The Power over Ethernet Splitter connect to the PD has two
connections –
Data out
and
Power out
.
There two types of voltages – 12V or 5V.
All manuals and user guides at all-guides.com
