Mikrotron EoSens CAMMC1186, Справочное руководство, Страница: 36 / 98

Acquisition Control
MIKROTRON GmbH 5 ‐ 2
Acquistion Control
Tip: Settings can only be
changed if image acquisi ‐
tion is stopped.
The following commands allow to make settings required for image
acquisition and to control an external trigger.
The following commands are availabel:
AcquisitionMode
This feature is used to set the device into a certain acquisition mode.
Up to now, only the mode continuous is available.
Name Access Length [Bytes] Register Interface Page
AcquisitionMode R/W 4 Enumeration 5 ‐ 2
AcquisitionStart W 4 Command 5 ‐ 3
AcquisitionStop W 4 Command 5 ‐ 3
TriggerSelector R/W 4 Enumeration 5 ‐ 4
TriggerMode R/W 4 Enumeration 5 ‐ 4
TriggerSource R/W 4 Enumeration 5 ‐ 5
TriggerActivation R/W 4 Enumeration 5 ‐ 6
TriggerCount R/W 4 Integer 5 ‐ 6
TriggerDebouncer R/W 4 Integer 5 ‐ 7
AcquisitionBurstFrameCount R/W 4 Integer 5 ‐ 3
TriggerSoftware WO 4 Integer 5 ‐ 5
ExposureMode R/W 4 Enumeration 5 ‐ 6
ExposureTime R/W 4 Integer 5 ‐ 7
ExposureTimeMax R 4 Integer 5 ‐ 7
AcquisitionFrameRate R/W 4 Integer 5 ‐ 7
AcquisitionFrameRateMax R 4 Integer 5 ‐ 8
Access
read / write
Type
enumeration
In
continuous the camera records continuously a sequence of
frames until it is stopped by the command
AcquisitionStop
Out
the selected mode
Remark
frame acquisition can be stopped with the feature
AcquisitionStop