See www.routerboard.com for more information. Contact [email protected] for support questions.
21/08/13
Next, put the two U-‐bolts (C) around the mast or pole, and guide
them through the holes on the swivel adjuster (D). Then, tighten
the U-‐bolts, each with one regular washer, one spring washer, and
one nut, as shown in the image to the right. All nuts need to be
tightened using a size 10 (3/8 in) wrench.
Now take the mounting bracket (E), and put it on to the
back of the antenna. Use one rubber ring, one washer, and
one nut for each of the built-‐in bolts (in that order).
Finally, attach the swivel adjuster to the mounting
bracket. Use the long bolt in the position (F). Put
one regular washer, and one spring washer onto the
shorter screws, then put them in positions (G). Do
not tighten too much, as you need to adjust the
antenna now.
Once antenna level and angle are adjusted
according to the wireless signal in software, tighten
all nuts. Note the degrees of angle for future
reference.
C
D
F
E
G
G
