See www.routerboard.com for more information. Contact [email protected] for support questions.
08/08/14
RouterBOARD QRT
series
Quick Setup Guide and Warranty Information
The RouterBOARD QRT comes as a complete kit. It includes a built
in dual chain wireless device, and a dual polarization antenna. It
has one Gigabit Ethernet connector which supports MDI-‐X auto
detection.
First use
1.
Connect an Ethernet cable to the port behind
the small plastic door
2.
The QRT accepts 24V Passive PoE from a PoE injector
3.
The default IP address from LAN is 192.168.88.1 for configuration from
a web browser
4.
Username is
admin
and there is no password
Powering
The device accepts powering from the Ethernet port (Passive PoE) 8-‐30V DC. Package contains a 24V
adapter. Maximum power consumption of the device is 21W @ 24V. s
Booting process
Initial connection has to be done via the Ethernet cable. Open
192.168.88.1
in your web browser.
Username is
admin
and there is no password. In case IP connection is not available, Winbox can be used
to connect to the MAC address of the device. More information here:
http://wiki.mikrotik.com/wiki/First_time_startup
In case you wish to boot the device from network, for example to use MikroTik Netinstall, hold the
RESET button of the device when starting it until the LED light turns off, and Metal will start to look for
Netinstall servers.
Buttons and Jumpers
•
RouterOS reset jumper hole (access through the plastic door) – resets RouterOS software to defaults. Must short
circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place
until RouterOS configuration is cleared.
•
RouterBOOT reset button (access through the plastic door) has two functions:
ü
Hold this button during boot time until LED light starts flashing,
release the button to
reset RouterOS configuration
(same result as with reset hole)
ü
Hold this button during boot time longer, until LED turns off,
and then release it to make the device
look for Netinstall servers.
Operating System Support
Currently tested operating system is MikroTik RouterOS (starting from version v6.2).
