See www.routerboard.com for more information. Contact [email protected] for support questions.
7-May-2012
Buttons and Jumpers
RouterOS reset jumper hole (on the bottom of case, behind one of the rubber feet) – resets RouterOS
software to defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example)
and boot the device. Hold screwdriver in place until RouterOS configuration is cleared.
RouterBOOT reset button (RESET, front panel) has two functions:
o
Hold this button during boot time until LED light starts
flashing
,
release the button to
reset RouterOS configuration
(same result as with RouterOS reset hole)
o
Hold this button during boot time longer, until
LED turns off,
then release it to make the RouterBOARD
look for Netinstall servers.
Operating System Support
Currently tested operating system is MikroTik RouterOS starting from version v5.15
Copyright and Trademarks.
Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part of it may be
reproduced or transmitted in any form without prior written permission from the copyright holder. RouterBOARD,
RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks
appearing in this manual are the property of their respective holders.
Hardware
. MikroTik warrants all RouterBOARD series equipment for the term of fifteen (15) months from the
shipping date to be free of defects in materials and workmanship under normal use and service, except in case of
damage caused by mechanical, electrical or other accidental or intended damages caused by improper use or due
to wind, rain, fire or other acts of nature.
To return failed units to MikroTik, you must perform the following RMA (Return Merchandise Authorization)
procedure. Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA
process.
1.
If you have purchased your product from a MikroTik Reseller, please contact the Reseller company
regarding all warranty and repair issues, the following instructions apply ONLY if you purchased your
equipment directly from MikroTik in Latvia.
2.
We do not offer repairs for products that are not covered by warranty. Exceptions can be made for
RB1000 series.
3.
Out-of-warranty devices and devices not covered by warranty sent to Mikrotikls will be returned to the
sender at sender's cost.
RMA Instructions are located on our webpage here:
http://rma.mikrotik.com
Manual
. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not
limited to, the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has
made every effort to ensure the accuracy of the contents of this manual, however, it is possible that it may
contain technical inaccuracies, typographical or other errors. No liability is assumed for any inaccuracy found in
this publication, nor for direct or indirect, incidental, consequential or other damages that may result from such
an inaccuracy, including, but not limited to, loss of data or profits. Please report any inaccuracies found to