See www.routerboard.com for more information. Contact [email protected] for support questions.
21-Aug-13
Buttons and Jumpers
•
RouterOS reset jumper hole (Reset2 in above image) – resets RouterOS software to defaults. Must short circuit the
metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold screwdriver in place until
RouterOS configuration is cleared.
•
Reset button (Reset1 in above image)
– Holding this button during boot time will make the RouterBOARD look for
Netinstall servers. Release the button after the LED light goes out.
Operating System Support
Currently tested operating system is MikroTik RouterOS (starting from version v5.21).
Copyright and Warranty Information
Copyright and Trademarks
. Copyright MikroTikls SIA. This manual contains information protected by copyright law. No part
of it may be reproduced or transmitted in any form without prior written permission from the copyright holder. Router-‐
BOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks
appearing in this manual are the property of their respective holders.
Hardware
. MikroTikls SIA warrants all RouterBOARD series equipment for the term of one year from the shipping date to be
free of defects in materials and workmanship under normal use and service, except in case of damage caused by mechanical,
electrical or other accidental or intended damages caused by improper use or due to wind, rain, fire or other acts of nature.
If you have purchased your product from a MikroTik Reseller, please contact the Reseller company regarding all warranty and
repair issues, the following instructions apply
ONLY
if you purchased your equipment directly from MikroTik Latvia
To return failed unit or units to MikroTikls you must perform the following RMA (Return Material Authorization) procedure.
Follow the instructions below to save time, efforts, avoid costs, and improve the speed of the RMA process. Take into ac-‐
count that all goods have one year warranty. Instructions are located on our webpage here:
http://rma.mikrotik.com
Manual. This manual is provided “as is” without a warranty of any kind, expressed or implied, including, but not limited to,
the implied warranty of merchantability and fitness for a particular purpose. The manufacturer has made every effort to en-‐
sure the accuracy of the contents of this manual, however, it is possible that it may contain technical inaccuracies, typo-‐
graphical or other errors. No liability is assumed for any inaccuracy found in this publication, nor for direct or indirect, inci-‐
dental, consequential or other damages that may result from such an inaccuracy, including, but not limited to, loss of data or
profits. Please report any inaccuracies found to [email protected]
