See www.routerboard.com for more information. Contact [email protected] for support questions.
rev. A (20-Apr-2011)
Federal Communication Commission Interference Statement (FCC ID:
TV7RB751G-2HND)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This device and its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
23 cm minimum distance has to be maintained between the antenna and the occupational user and 75 cm to general public. Under such
configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satisfied.
List of additional approved antennas:
Omnidirectional Antenna, SF-245, 7.4dBi
Flat panel Antenna, AAl-00089, 8.5 dBi
Antenna Installation. WARNING:
It is installer's responsibility to ensure that when using the authorized antennas in the United States (or
where FCC rules apply); only those antennas certified with the product are used. The use of any antenna other than those certified with the
product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the output power level of
antennas, according to country regulations and per antenna type. Professional installation is required of equipment with connectors to
ensure compliance with health and safety issues.
