Configuration
The device is set up as a switch, with 192.168.88.1 as the management IP of the master interface.
SwOS is an operating system designed specifically for the administration of MikroTik switch products.
SwOS is configurable from your web browser. It gives you all the basic functionality for a managed switch, plus more: allows you to manage port-to-port
forwarding, broadcast storm control, apply MAC filter, configure VLANs, mirror traffic, apply bandwidth limitation and even adjust some MAC and IP header
fields.
https://wiki.mikrotik.com/wiki/SwOS/RB250_RB260
Power Output
The CSS106-1G-4P-1S model can supply PoE powering to external devices from its Ethernet ports. This is convenient, as you don't need any additional
PoE injectors to power other devices. The output voltage will be the same as the input Voltage. By default, it is set to "auto", so it is safe to plug any device
into the powered ports. The maximum power output of each ethernet port in this mode is 1 A, total for all ports 2 A. Once Power Output is enabled in
RouterOS, the Ethernet LED light turns from Green to Red. Red LED means the port is currently providing PoE power. For the best PoE output
functionality, please use the power jack to power the CSS unit.
Buttons and Jumpers
Hold this button during boot time and release after LED light stops flashing to reset SwOS configuration and load primary backup firmware.
Access to primary firmware allows the reinstallation of the main firmware.
https://wiki.mikrotik.com/wiki/SwOS/RB250_RB260#Reset
Operating System Support
The CSS runs SwOS, which is the only supported OS for this device. Information about SwOS:
https://wiki.mikrotik.com/wiki/SwOS
GSP Models:
