Resetting the device
The reset button is located below the ethernet port, and has three functions:
• Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configu-
ration (total 5 seconds).
• Keep holding for 5 more seconds, LED turns solid, release now to turn on CAPs management mode
(total 10 seconds).
• Or Keep holding the button for 5 more seconds until until LED turns off, then release it to make the Router-
BOARD look for Netinstall servers (total 15 seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is
pressed before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Federal Communication Commission Interference Statement
FCC ID: TV7LHG5NDM,TV7LHG5ACD.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable pro-
tection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor-
dance with the instructions, may cause harmful interference to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. This device and
its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation. 13 cm minimum distance has to be maintained between the
antenna and the occupational user and 28 cm to general public. Under such configuration, the FCC radiation expo-
sure limits set forth for an population/uncontrolled environment can be satisfied.
Antenna Installation. WARNING:
It is installer's responsibility to ensure that when using the authorised antennas
in the United States (or where FCC rules apply); only those antennas certified with the product are used. The use
of any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules
CFR47 part 15.204. The installer should configure the output power level of antennas, according to country regula-
tions and per antenna type. Professional installation is required of equipment with connectors to ensure compliance
with health and safety issues.
Industry Canada
IC: 7442A-LHG5NDM, 7442A-LHG5ACD.
This device complies with Industry Canada licence-exempt RSS stan-
dard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2)
l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
See www.mikrotik.com for more information. Contact [email protected] for support questions.
04/08/2017
