6
o
Hold this button during boot time longer, until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers.
RouterBOOT
The RouterBOOT firmware (also referred as Bootloader here) provides the basic functionality to boot an
Operating System. It supports serial console via the onboard serial port at the boot time. The loader supports
booting from the onboard NAND device and from a network server (see the respective section for details on
this protocol).
Boot Loader Configuration
This de i e does ’t o e fitted ith a serial port o e tor, so all Bootloa
der specific settings must be done in
RouterO“. “ee „
RouterOS functions
”
Boot Loader Upgrading
The boot loader is needed to initialize all the hardware and boot the system up.
The boot loader upgrading is possible
fro MikroTik RouterO“, fro ithi the /s ste router oard e u.
Updates are included with each RouterOS update. The procedure is described in the MikroTik RouterOS
manual:
http://wiki.mikrotik.com/wiki/Manual:Bootloader_upgrade
RouterOS functions
The default OS of RouterBOARD devices is RouterOS, when the
routerboard.npk
package is installed, RouterOS
can configure some RouterBOARD hardware settings
Firmware information
This menu displays RouterBOARD model number, serial number, the current boot loader version and the
version available in the current software packages installed.
[admin@MikroTik] > system routerboard print
routerboard: yes
model: "rb750"
serial-number: "154201C1DD3C"
current-firmware: "2.26"
upgrade-firmware: "2.27"
[admin@MikroTik] >
The firmware version can be upgraded from
RouterOS
by
usi g
/system routerboard upgrade
command.
Firmware Settings
Boot loader settings are also accessible through this menu.
[admin@MikroTik] > system routerboard settings print
boot-delay: 2s
boot-device: nand-if-fail-then-ethernet
boot-protocol: bootp
enable-jumper-reset: yes
[admin@MikroTik] >
Boot-device
:
use this to enable Netinstall
Boot protocol:
for Netinstall use Bootp, for installing other operating systems, you need to use DHCP
Enable-jumper-reset
:
Disable this to avoid accidental setting reset via the onboard jumper
