mikroElektronika mikroProg for PIC, Руководство пользователя

Страница: 12 / 44

Page 12 Page 13
5. Connecting with
a target device
For connection with a target device mikroProg for PIC uses IDC10
connector, Figure 5-1. In order to make proper connection with the
target board it is necessary to pay attention to IDC10 connector
pinout. Every pin has a different purpose and for easy orientation
IDC10 connector is marked with a little knob and incision, Figure
5- 2 . First pin on IDC10 is marked with colored wire on a flat cable.
Front side of IDC10 connector is marked with a knob and incision.
Front side holds PGC, PGD and MCLR pins which are used for
microcontroller programming.
Figure 5-1: IDC10
connector
Figure 5-2: Knob
and incision for easy
orientation
First pin