M I K R O E L E K T R O N I K A S O F T W A R E A N D H A R D W A R E S O L U T I O N S F O R T H E E M B E D D E D W O R L D
EasyAVR
USB
4
EasyAVR4 User
’
s Manual
MikroElektronika
Development
tools
8
8
page
MM
CC
UU
SS
OO
CC
KK
EE
TT
SS
MCU SOCKETS
EasyAVR4 is delivered with a ATmega16 40-pin microcontroller. Users can remove this one
and fit a different microcontroller in DIP40, DIP28, DIP20, DIP18, DIP14 or DIP8 packages
of an adequate pinout.
Note:
Since all packages have parallel connections, there must not be more than one micro-
controller on the board at a time.
Figure 5.
MCU sockets
Note:
Jumper J13 should be enabled only if you want to use DIP8 microcontroller with
external clock source.
Note:
There are two DIP40 sockets, with different pinouts (SKT1 and SKT2). When put-
ting 40-pin microcontoller into DIP40 socket choose the one with corresponding pinout. For
example, ATmega8535 uses SKT2 socket, while ATmega8515 uses SKT1 socket.
