Page 16
The microcontroller can also
be programmed with the
ST-LINK V2 programmer
and mikroProg Suite
™
for
ARM
®
software, Figure 5-1.
This programmer connects
with mikromedia board via
mikroProg to ST-LINK V2
adapter (Figure 4-11).
Programming with ST-LINK V2 programmer
Figure 4-12:
Connecting ST-LINK
™
V2 programmer
Figure 4-11:
mikroProg
™
to
ST-LINK
™
V2 adaper
Page 16
In order to adjust the ST-LINK
™
V2 programmer
to be connected to the development system, it
is necessary to provide the appropriate adapter
such as the mikroProg to ST-LINK V2 adapter.
2x5 male headers should be first soldered on
the CN2 connector pads. Then you should plug
the adapter into the ST-LINK V2 programmer
(2x10 header), and plug an IDC10 flat cable in
headers, Figure 4-12.