Mikroe mikromedia 3, Руководство пользователя

Страница: 8 / 32

P A G E 8
mikromedia 3 for PIC32MZ CAPACITIVE U S E R M A N U A L
MCUs FEA
TURES
1
4
3
2
Figure 3: Front and back partial view
The host MCU (1) an be programmed and debugged over the Microchip
ICSP compatible 2x5 pin header (2) , labeled as PROG/DEBUG. This header
allows an external programmer (e.g. CODEGRIP or mikroProg) to be used.
Programming the microcontroller can also be done by using the bootloader
which is preprogrammed into the device by default. All the informations
about the bootloader software can be found on the following page:
www.mikroe.com/mikrobootloader
The board is equipped with the Reset button (3) , which is located on the
front side of the board. It is used to generate a LOW logic level on the
microcontroller reset pin. The reset pin of the host MCU is also routed to
the pin 1 of the 1x26 pin header
(4) , allowing an external signal to reset
the device.
1.1 Microcontroller programming/debugging
1.2 MCU reset