Mikroe Codegrip, Руководство пользователя

Страница: 42 / 44

P A G E 42
C O D E G R I P U S E R M A N U A L
TROUBLESHOO
TING
Error Messages Troubleshooting
Target is not detected (DETECT)
Make sure that the selected MCU matches the MCU connected to the
CODEGRIP device.
Connecting to target failed
Check that the selected interface (SWD / JTAG) is supported on the
target MCU. Make sure that the program lines are correctly configured.
Try to connect with the “Under reset” and “Halt on connect” options
enabled.
Special cases:
1) The “Under reset” option is not available for MSP and TIVA MCU families.
2) The “System reset” option is not available for STM32 MCU families.
Selected chip not recognized (All buttons except DETECT)
Make sure that the selected MCU matches the MCU connected to the
CODEGRIP device.
File not verified
The content in the MCU flash differs from the contents of the source file.
Make sure the MCU is not read-protected.WW
Operation failed (VERIFY, READ)
Check the communication with the CODEGRIP device and the connection
between the CODEGRIP device and the MCU.
Disconnect from target failed
CODEGRIP Suite lost the connection to the CODEGRIP device before the
operation was completed.
Interface to target currently being used Make sure there is no Debug or SWO process in progress.
Your board doesn’t support selected vendor Make sure your MCU card is compatible with the development board.
Firmware erase error
The firmware erase operation failed. Check the connection to the
development board and try again.
Firmware write error
Firmware update failed. Check connection with the development board
try again.
File not verified
Firmware is not programmed properly. Try the firmware update process
again.
WiFi link authentication failed
Link is protected by password in Link Password field. Please enter correct
password.