Mikkelsens Elektronikk
Page 3 of 3
CO — RU 200
Address: Nygaardstubben 5 Phone: +47 66 91 92 95
Giro: 9710.4771789
Company no: NO-946971243 MVA
N-1454 Fagerstrand
Fax: +47 66 91 51 81 E-mail: [email protected] Internett: http://www.mik-el.no
Montage:
First place the monitor-unit (loudspeaker) between the recordplayers in such a manner that You can
operate all units without any problems. Remove the protective cover on the bak of the drilling drawing
and stick to the table where You want the monitor-unit to be. Drill two 4.5MM. holes and one 25MM.
hole in the table. Remove the drawing, put the cable from the monitor-unit through the table and fasten
the unit with two 4X40MM. screws from underneath the table. The unit may be slightly out of vertical
alignment, that`s quite normal.
NB!
Be aware of that if the table is thinner than 25MM. then the screws must be shortend or changed to
two shorter 4MM. screws
NB!
If the table are thicker than 35MM. one have to use longer screws.
Max. length of the screws are the table thi 15MM.
Min. length of the screws are the table thi 5MM.
Then You mount the main-unit underneath the table using four wooden screws (not included) in such a
place that all cables are going nicely to and from the unit. The cable from the monitor-unit are connected
to the main-unit. The power-supply are connected to the mains, and the cable are also connected to the
main-unit.
The sound connections are made according to the description on page 2.
On most proffesional recordplayers there are a separate earth-wire. If it exist, be carefully to connect them
together (one from each recordplayer) at the terminal post marked GND. Failure to do so will result in a
strong hum at the outputs of the unit.
