Mikasa MTR-40H, Инструкция по эксплуатации

Страница: 16 / 22

12
While the plug is removed, pull the starter handle
2 to 3 times to discharge any fuel from the
cylinder.
CAUTION
䟿
Shifting the lever slowly will cause irregular
operation and damage the clutch, springs, and
foot.
WARNING
䟿
If the rammer is used on sloping ground, check
the safety of the surroundings and be careful not
to allow the machine to fall over.
WARNING
䟿
㻲㼕㼓㻚㻝㻜
THROTTLE
LEVER
IDLE POSITION
OPERATING POSITION
䜰䜲䝗䝸䞁䜾㻔ప㏿㻕
THROTTLE
LEVER
IDLE POSITION
OPERATING POSITION
㻲㼕㼓㻚㻝㻝
In the cold season, the grease in the machine
will be thicker, and the resistance of the
components will be much larger, which may
cause irregular motion. Shift the throttle lever
from the operation to the idle position several
times and allow it to warm up sufficiently before
starting actual work.
The surface of the foot in contact with the ground
is a metal sheet that has excellent wear
resistance. However if you need to tamp ground
that contains large stones (about the size of a
fist), first put some fill soil over them so that the
foot will tamp the ground evenly.
The machine body will advance as it jumps. If
you want to move forward faster, push the
handle a little forward to make the machine body
lean a little forward.
To halt work, quickly slide the throttle lever from
the operation position to the idle position. Do not
slide the throttle lever slowly.(Fig. 11)
㻞㻚
㻟㻚
㻠㻚
㻡㻚
After the engine has started, open the choke lever
gradually until it is wide open. Pay attention to the
sound of the engine to guide you in the amount to
open the choke. After the engine has started, be
sure to warm up the engine at low speed for 3 to
5 minutes. During this time, check the machine for
leaking fuel, abnormal sounds, or abnormal
exhaust color or odor.
If the engine cannot be started after pulling the
starter handle several times, remove the spark
plug and see if it has a spark. If the plug is wet
from fuel (due to flooding from the carburetor), or
if it is stained, replace the plug or clean it
thoroughly.
Shift the throttle lever from idle to the operating
position and the tamping rammer will start up
and down motions. (Fig. 10)
5.
6.
1.
When warming up, if in the semiclutch in
order not to be,pay attention to engine
speed.
CAUTION
䟿