Safety Instructions
An R/C controlled helicopter is not a toy!
While moving,
the rotor blades pose a serious danger to persons and things.
You must obey all safety instructions of the manufacturer for
operation of your helicopter.
VBar is not an autopilot!
VBar may be installed in model
helicopters which are suitable for flying without flybar. During
installation and operation you must follow all instructions given
in the software of the radio and in manuals. VBar may not be
operated in wet conditions (high humidity or rain). If the heli-
copter shows vibrating behavior during flight, operation of the
helicopter is to be stopped immediately. Do not continue flying
until the cause for vibration has been eliminated.
•
Since the ESC is directly connected to the VBar,
disconnect the motor wires or remove the pinion gear
to avoid accidental spooling up of the helicopter while
setting up the speed controller (ESC) functions. The
same applies when loading unknown setup or preset-
files, as they may transport other receiver and speed
controller settings as you have on your heli!
•
The external gyro sensor (set with sensor included)
must not be connected to a different connector than
Sensor, else it will be destroyed beyond repair imme-
diately.
•
Make sure you use a sufficient power supply.
•
Fail safe will be set automatically by VBar/VBar Control
(motor off, servos on hold position).
