Bag 09
The canopy of the LOGO 700 is mounted via four attachment points. The two attachment points
in the front ensure that the canopy sits well on the chassis during fl ight. have a guiding function. In
the back, the canopy is attached by two rubber grommets. You will fi nd another, high-quality, set of
rubber grommets included in the kit. You may use these, if desired.
Important note: A special feature of the Logo 700 canopy ist that it the back part is fully closed. This
back area is connected via two pins and magnets. Take your time when mounting and dismounting
the canopy. Use proper care when sliding the canopy over the rotor shaft.
Before each fl ight, check that the canopy sits securely. If the canopy sits too lose, this can deteriorate
the fl ight performance of the helicopter. If the canopy becomes lose during fl ight the helicopter will
crash.
This canopy is 100% hand-made. Small irregularities in the surface, the airbrush design or color are
normal. They do not constitute a reason for complaint
Please mount here the edge protector strip
(included in the kit) and fi x it with speed glue.
In case the upper rotor head links are too close to the inner edges
of the canopy, take out a few mm as shown in the picture.
Manual LOGO 700 - ©Mikado Model Helicopters GmbH - Page 19
14 Canopy and Overview
2x
2x
2x
8x12x2,5
