Miha BODYTEC II, Руководство по эксплуатации

Страница: 94 / 114

Before starting with the workout (countdown) and during the pulse
phases, the electrodes connected via the channel outputs are
detected.
If a pair of electrodes is not detected before starting with the
workout (countdown), the corresponding channel is shown in gray
on the display and cannot be reactivated during the training ses-
sion. If this happens even though something was connected to this
channel, remove the transponder card again right away at the start
of the workout. This ends the training session. Next, check to make
sure that the contacts are properly connected and the electrodes
are sufficiently moistened. Correct the problem, if necessary.
If the contact of a channel is interrupted unexpectedly during the
workout, the intensity of the channel drops to “0” and cannot be
increased again afterwards. The channel is shown in gray on the
display. The channel intensity can only be increased again once
the electrode is properly reconnected.
Personnel: n Athlete/Patient
n Trainer
Fig. 57: Control unit
1. Select the program by turning the multi-function button
(Fig. 57/13).
2. Read and check the parameters of the selected program by
turning the main controller (Fig. 57/14).
3. Confirm the desired program by pressing the multi-function
button (Fig. 57/13).
4. Adjust the application time if necessary by turning the multi-
function button.
5. Press the multi-function button to start the program.
ð
The time at the top right in the display starts running.
Electrode detection/channel shutoff
Working out
Overview of programs/training plans
2021-07-28 miha-bodytec II EMS training device 94