ASSEMBLY INSTRUCTIONS
Please keep these instructions for future reference. Adult assembly required.
This table is not a toy & is intended for use under the supervision of adults.
Suitable for 8 years & above.
1.
Find a clean & level place to begin the assembly of your MINI KICK table football game. It will be assembled
upside down & then turned over onto its legs once complete.
2.
Remove all parts from the box & verify you have all the pieces that are listed in the ‘Parts Identifier’. Carefully
cut or tear the four corners of the box so that the bottom can be used as your work surface. Save all packing
materials until the parts have been inspected & the table is assembled.
3.
Place one side panel #1 upside down with the finished side facing out – the ball entry hole will be closest to
the floor. To ease assembly push the bumpers & washers ((#10 & #11) onto the rods, up against the men.
Insert the rods through the holes in the side panel. Alternate the black player rods with the white player rods.
The handle end of the rod has a hole close to the end of the rod. There will be three handles (one team) on
each side of the table. Remember that the goalie rod is always in your left hand when the table is in the upright
position – you are working upside down so it will be opposite during assembly.
4.
Once you are sure you have all the players set up correctly, slide the other side panel #1 on to the other end
of the rods.
5.
Set the playfield #3 on top of the assembly with the graphics facing down & insert it into the grooves on the
side panels.
6.
Place the playfield support brace #4 on the bottom of the playfield, then slide the support rod #6 through the
side panel & into the groove of the support brace. Secure with finishing nut #7. DO NOT TIGHTEN AT THIS
TIME.
