5
Intercom Description
Normal Keypad operation:
• If the user enters a 4-digit code that is matched to one of the
25 stored codes, the STATUS light should blink twice and the
beeper should beep twice to confirm that a matched code is
entered.
• No more than 20 key presses are allowed to obtain the 4-digit
entry code.
Example:
1234 is one of the codes stored in one of the memory location.
The user can enter ‘x1234’ or ‘xxxxxxxxxxxxxxxx1234’ and
the gate should be activated (x is any key). If more than 20 key
presses is entered without matching one of the codes, then the
STATUS light should be flashing rapidly and no entry will be
accepted for the next 40 seconds. The user must not enter any
code for at least 40 seconds before the unit returns to normal
operation. Otherwise it remains in this ‘lock-down’ mode.
Once
the user enters a matched code, any subsequent key press
within the next 40 seconds will re-activate the keypad.
Delete ALL Entry Codes:
• Press and release PROGRAM button.
• Enter the Master Code then press and release PROGRAM
button.
• Enter 0, 7 then press and release PROGRAM button.
• Beeper beeps 3 times to confirm that the All Entry Codes are
deleted.
Example: Key press sequence to delete all entry codes from
memory. (1234 is the Master Code)
The round black dot is the ‘PROGRAM’ button.
1 2 3 4 0 7
GRANT ACCESS Button
:
The GRANT PERMISSION button must be pressed then
the person at the keypad can press any key to open the gate.
Intercom - Face
PUSH TO ANSWER/TALK Button
:
Used to answer CALL from keypad.
HOLD to talk - RELEASE to listen.
POWER
Keypad
Batt Low
Grant P
ermission
Push T
o Answer/T
alk
End Call
DV 9V
POWER Light
:
LED is GREEN when charging on AC power source and RED during battery
power mode. Blinking RED indicates low battery on Base unit.
KEYPAD BATTERY INDICATOR Light:
LED turns ON when keypad battery is low.
9 Vdc Transformer Plug:
Transformer plugs here to charge the base unit battery.
ID SE
T
VO
LUM
E
POWE
R
O
FF
O
N
Intercom - Bottom
ON/OFF Switch
:
Turn OFF to conserver power when battery operated.
VOLUME Control
:
Controls volume level of speaker.
ID SET button
:
This button is used only when there is another pair of
GTO wireless intercom units nearby causing interference.
END CALL Button
:
Allows user to terminate the call.
BATTERY ACCESS Cover
:
Rechargable 3.6 Volt Ni-MH battery included.
