Mighty Mule MM271, Руководство по установке

Страница: 9 / 20

9
NOTE: DO NOT PERFORM THIS STEP BEFORE FOLLOWING STEP 3!
The IDC Self Stripping Connectors will not fit through the Strain Relief Fitting and must be connected after the existing
battery harness has been fed through .
Connected to
MM271 Control Box
Press black cap
down to secure
Press black cap
down to secure
5.
Splice the two harness sections together using the two provided IDC Self Stripping Connectors , ensuring that the new
harness will rest within the Battery Enclosure Kit .
Insert alike wires (Black-to-Black and Red-to-Red) into one connector, then use press firmly with your thumb (or use
pliers) to press down on the black cap to snap and secure the connection .
NOTE: Once an IDC Self Stripping Connector is snapped and secured, it cannot be removed without damage .
INSIDE BATTERY BOX

Connected to
MM271 Control Box
Splice Wires of Existing
Battery Harness
4.
Feed the spliced end of Battery Harness A (connected to the MM271 Control Box) through the Strain Relief fitting from
underneath the Battery Enclosure Kit . The wiring harness will then need to be constructed and sealed inside the Battery
Enclosure Kit .
