Migatronic PILOT 200 HP, Инструкция по эксплуатации

Страница: 14 / 36

14
MAINTENANCE
The PILOT welding machines require virtually no
maintenance. However, exposure to extremely dusty,
damp or corrosive air is damaging to welding
machines.
In order to prevent problems arising, the following
procedure should be observed at least once a year.
-
open the machine and clean it with clean, dry,
compressed air
Lack of maintenance can lead to reduced reliability
and cancellation of the guarantee.
LOCATIONS OF ERRORS
Attempts to locate errors should only be made by
trained experts.
The machine does not work and/or the display does
not light:
Check that mains fuse has not been damaged and
that mains supply is switched on. Replace fuse
and/or switch on supply if necessary
Mains error:
Occurs if there is too low or too high voltage on the
supply mains.
Ensure that mains fuse and supply are as specified.
Overheat:
Occurs if the machine is overloaded. This occurs
when welding with higher load than permitted, or if
the machine needs cleaning.
Ensure machine data or clean modules with clean,
dry, compressed air through the cooling ducts.
When the error has been corrected, the machine
should be switched off and then started again to
remove error indication.
WARRANTY
All MIGATRONIC machines carry a twelve-month
guarantee against hidden defects. Such defects must be
notified no later than two months after it has been noticed.
The warranty runs for twelve months after invoicing to end
customer.
The warranty covers material and manufacturing faults that
cannot be immediately acknowledged.
Lapse of warranty
The warranty covers no obvious product characteristics,
which in time are thought as being inconvenient.
Incorrect installation
The warranty does not cover defects due to incorrect
installation of the product, e.g. connection to the wrong
mains voltage.
Incorrect or abnormal use of the product
The warranty does not cover use of the product for other
purposes than it has been designed for.
If the product is
used for more than 8 hours daily, the warranty does not
cover defects due to these intensive working
conditions.
Lack of maintenance
There is a lapse of warranty if the product is not properly
maintained. E.g. if the product is dirty to such a degree that
cooling is hindered. The warranty does not cover damages,
which can be traced back to unauthorised and lacking re-
pairs of the product.
Over loading/extreme loading
The warranty does not cover over loading or extreme
loading. Nor transport damages, damages due to incorrect
handling, drops etc. The warranty does not cover abnormal
conditions as regards temperature, moisture or environ-
mental loading above the limit, which the machine has been
designed for.
Defects due to infestants
The warranty does not cover defects due to infestants.
Wear parts
The warranty does not cover parts of the product, which is
exposed to wear and tear, e.g. the
welding torch and
welding cables
. The warranty does not cover depreciation
due to normal use, e.g. scratches, rust and mechanical
damage. Welding cables and welding hoses are regarded
as wear parts and therefore not included in the warranty.
Resulting damages
Use of the product must stop immediately after acknow-
ledge of a defect in order to avoid further damage of the
product. The warranty does not cover resulting damages
due to use of the product after acknowledge of a defect.
Moreover, the warranty does not cover resulting damages
on other items due to product defect.