Migatronic Automig 140 Mono X, Инструкция по эксплуатации

Страница: 6 / 15

6
CONTROL SWITCHES/INSTRUCTIONS
1.
Welding time: With this switch the welding time is chosen, when 2 is in position: interval and spot.
2.
Switch:
Seam:
The switch is set at seam. The trigger on the welding handle is activated, welding starts. By letting go the
trigger you stop the welding process.
Spot:
The switch is set at spot. When the trigger on the welding handle is activated, welding starts. Welding
automatically stops, depending on the time adjusted by button 1 (0.2-1.5 sec.)
Interval:
The switch is set at interval. When the trigger is activated, welding starts. The welding automatically
stops, depending on the time adjusted by button 1. After an interval fixed at button 3 the same cycle
continues automatically and is only interrupted when the trigger on the welding handle is released.
3.
Adjustable pausetime: With this button the pause time is chosen, when button 2 is in position: interval.
4.
Wire speed : With this button the wire feed speed is adjusted, depending on the welding voltage and wire
diameter.
Wire speed range: 2-12 m/min.
5.
Control lamp: Lights when the machine is on.
6.
Fuse
7. Adjustment of welding voltage and main switch ON-OFF.
8. Earth cable (only at Automig 185X).
9. Connection for bolt welding hose (only at Automig 185 X).
10. Pilot cable for bolt welding hose (only at Automig 185 X).