Problem solving guide
84
Fault message after a programme has been interrupted.
Problem
Cause and remedy
Water intake fault.
Open the stopcock.
The water inlet is blocked or restricted.
Check whether the stopcock has been properly
opened.
Check whether the water inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
Drainage fault. Clean
drain filter and pump.
Check the drain
hose.
The drain is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
Check whether the maximum delivery head of 1 m
has been exceeded.
Waterproof system
activated. Close
stopcock and call
Service
The water protection system has reacted.
Close the stopcock.
Call the Miele Customer Service Department.
Fault F. If restart
fails, call Service.
There is a fault.
Disconnect the washer-dryer from the electricity
supply. Switch off at the wall and withdraw the
plug from the socket, or disconnect the fuse.
Wait
at least 2 minutes
before reconnecting the
washer-dryer to the electricity supply.
Switch the washer-dryer back on.
Restart the programme.
If the fault message appears again, contact the
Miele Customer Service Department.
To switch off the fault message, switch the washer-dryer off with the
button.
Содержание WTR 860 WPM
Страница 128: ...M Nr 11 584 430 02 en GB WTR 860 WPM ...