Miele WS 5240, Руководство по эксплуатации

Страница: 24 / 36

Setting the amount dispensed by the
pump
The amount to be dispensed is measured in
liters in the service program.
The dispensing time fixed is then set in oper-
ating mode
C "Programming".
^
Insert the suction pipe into a measuring
container with sufficient proofing agent
and maintain the fill level.
SERVICE-OPERATION
>SERVICE PROGS< MACHINE DATA
After selection press Start button.
^
After selection press the
X
"Start" button.
Select SERVICE PROGRAMME 2 and
press the
X
"Start" button.
SERVICE-OPERATION SERVICE PROGS
SERVICE PROGRAMME 2
Dispenser valve >D1< Disp. time 0 Secs.
After selection press Start button.
^
With the
4
"Plus" button select D6.
^
With the cursor button move to the input
field for dispensing time and with the
4
"Plus" button set a dispensing time.
SERVICE-OPERATION SERVICE PROGS
SERVICE PROGRAMME 2
Dispenser valve >D6< Disp. time 35 Secs.
After selection press Start button.
^
Press the
X
"Start" button and the pump
will draw a certain amount from the mea-
suring container.
^
Repeat this process until the desired dis-
pensing amount is set.
Maintain the dispensing time because this
time must be carried over into the program
to be run.
^
Cancel with the
7
"End" button and turn
off the machine.
^
Turn on the machine and select Separate
Drain, to flush the proofing agent deter-
gent out of the machine.
^
Set the access key to position C "Pro-
gramming" and select menu point ALTER.
^
Select the number of the Proofing program
with the
4
"Plus" or
3
"Minus" button.
Press
X
"Start".
^
If the
U
"Starch" button is pressed, the
LED lights up, and then the
2
"Cursor" (or
1
) is pressed, the cycle is skipped
through to the end (or back again). In the
area programming and at each end of a
block the skipping is stopped and the dis-
play calls for "saving".
If the
X
"Start" button is pressed this
jumps into the next block.
PROGRAMMING ALTER
PROGRAMME 18 WASH/PROOF & SPRAY
Dispensing 1 >D 1/ 0 Secs, D 1/ 0 Secs <
Disp. delay 1 >no<
~
^
Once the dispensing point has been
found, set D6 with the
4
"Plus" button and
with the
2
"Cursor" move to the input field
for dispensing time, and with the
4
"Plus"
button set the fixed dispensing time.
PROGRAMMING ALTER
PROGRAMME 18 WASH/PROOF & SPRAY
Dispensing 1 >D 6/ 60 Secs, D 1/ 0 Secs<
Disp. delay 1 >no<
~
^
Skip the program through to the end and
press
X
"Start" to save.
^
To start the program turn the access key to
position
B "Operation".
Liquid dispensing
24