Miele WKH 120 WPS, Руководство по эксплуатации

Страница: 78 / 104

Installation and connection
78
Installation surface
A concrete floor is the most suitable in‐
stallation surface for a washing ma‐
chine, being far less prone to vibration
during the spin cycle than wooden
floorboards or a carpeted surface.
Please note:

The machine must be level and se‐
curely positioned.
 To avoid vibrations during spinning,
the machine should not be installed
on soft floor coverings.
If installing on a wooden joist floor:

We recommend a plywood base at
least 59 x 52 x 3 cm). The base
should span several joists and be
bolted to the joist and not only the
floorboards. Check for the presence
of pipes and cables first.
Tip: If possible, install the machine in a
corner, as this is usually the most stable
part of the floor.

If the machine is installed on a
raised plinth, it has to be secured
against slippage during spinning us‐
ing retaining clips (available from
Miele). Otherwise there is the danger
of the machine moving and falling off
the plinth.
Transporting the washing ma‐
chine to its installation site
To manoeuvre the washing machine out
of its packing case to its installation
site, hold it by the front feet as well as
by the edge of the lid where it protrudes
to the rear of the machine.

Ensure that the machine feet and
the floor are dry to prevent the ma‐
chine from slipping during the spin
cycle.
Removing the transit bars

To remove the left and right covers
1. Pull on the attached stopper,
2. then use a screwdriver to release the
catches at the top and bottom.