en – US
M.-Nr. 10 671 390
Quick Start Guide
Heat-pump dryer
These short instructions are not a substitute for the operating instructions supplied with
the appliance! It is essential to familiarize yourself with the dryer before using it for the first
time.
Take note of the operating instructions, as well as the "IMPORTANT SAFETY
INSTRUCTIONS".
Cleaning and care
Frequently asked questions
Lint filters
Removing visible lint
Clean both lint filters in the door opening
after every drying cycle.
寿
Remove the fragrance capsule (if fit-
ted).
ĺ
Pull the upper lint
filter forward to
remove it.
ĺ
Use your fin-
gers or a vac-
uum cleaner to
remove the lint
from the surface
of the filter.
ĺ
Push the upper lint filter back into posi-
tion until it clicks.
ĺ
Close the door.
Cleaning the lint filters and air flow
openings thoroughly
If the drying duration has become longer
or the surface of the filters is visibly com-
pacted with lint, you should carry out the
following cleaning procedure.
ĺ
Pull the upper lint filter forward to remove
it.
ĺ
Turn the yellow
dial on the lower
lint filter in the
direction of the
arrow (until you
hear it click).
ĺ
Hold the dial and
pull the lint filter
forward to
remove it.
ĺ
Use a vacuum
cleaner to
remove any
visible lint from
the upper air flow
openings.
ĺ
Flush the lint filters through with warm
running water.
ĺ
Shake out the lint filters thoroughly and
then dry them carefully.
寿
Ensure the filters are dry before replac-
ing them.
ĺ
Refit all of the lint filters and close the
door.
CLEANING AND C
ARE
FREQUENTL
Y ASKED QUES
TIONS
Program guide
PROGRAM GUIDE
Garment car
e label symbols
Dr
ying
Normal/higher t
emper
atur
e
Reduced t
emper
atur
e: Select
Gen
-
tle
(for delicat
e t
extiles)
Do not tumble dr
y
Ir
oning
Ver
y hot
Hot
W
arm
Do not ir
on
T
ips on dr
ying
–
Always obser
ve the maximum r
ecom
-
mended load for each pr
ogr
am (see P
ro
-
gr
am guide).
寿
Overloading can cause unnecessar
y
wear and t
ear t
o the laundr
y, give a dis
-
appointing dr
ying r
esult and cause mor
e
cr
easing.
–
Do not load the drum with it
ems that ar
e
still soaking wet. Mak
e sur
e your laun
-
dr
y is spun at the maximum spin speed
befor
e dr
ying.
–
Minimum ir
on fabric t
ends t
o cr
ease
mor
e, the lar
ger the load. This is par
tic
-
ularly the case for garments made fr
om
ver
y fine weave fabric, such as dr
ess
shir
ts or blouses.
Plinth filter
Only clean the plinth filter when
Clean lint
and plinth filter See
lights up.
To turn the message off: Switch the dryer off
and then on again. Confirm with
OK
.
ĺ
Press the round,
indented area on
the heat
exchanger access
panel to open it.
The access panel
will spring open.
ĺ
Pull the plinth filter
out by the handle.
A guide pin in the dryer will come out which
prevents the access panel from closing with-
out the plinth filter.
ĺ
Pull the handle
out of the plinth
filter.
ĺ
Clean the filter
thoroughly under
running water.
ĺ
Squeeze the water out of the plinth filter
thoroughly.
寿
The plinth filter must not be replaced
dripping wet.
ĺ
Use a damp cloth
to remove any
lint.
Checking the heat exchanger unit
寿
Danger of injury! Do not touch the
cooling fins with your hands. You could cut
yourself.
ĺ
Carefully vacuum
up any visible fluff
or dirt.
Refitting the plinth filter
ĺ
Fit the filter back
on the handle.
Make sure it is the
correct way
round.
ĺ
First insert the
handle with the
plinth filter
attached over the
two guide pins.
The word Miele on the handle must be the
correct way up.
ĺ
Close the heat exchanger access panel.
Some of the messages in the display are more than one line long. Touch the
or
sensor
button to read them in full.
Problem/Fault message
Possible cause and solution
000
lights up after
the tumble dryer is
switched on and a
program cannot be
selected
Access via a PIN code has been activated.
You must enter the correct PIN code to use the tumble dryer.
See "Settings menu – PIN Code" in the operating instruc-
tions.
The program is can-
celed and the following
lights up:
Empty container. See
The condensed water container is full or there is a kink in the
drain hose.
ĺ
Empty the condensed water container.
ĺ
Check the drain hose.
To switch off the message:
ĺ
Open and close the door while the dryer is switched on.
Fill condensate container
This is to remind you that water is taken from the condensed
water container when the
SoftSteam
program is being used.
The condensed water container must be filled with water to
at least the –
min
– marker.
ĺ
Confirm with
OK
.
Open & close door.
This it to remind you to load the laundry when the
SoftSteam
program is selected.
ĺ
Load the laundry in the drum.
At the end of a program
the following lights up:
Clean the lint and plinth
filter See
There is a build-up of fluff in the airways. See "Cleaning and
care" in the operating instructions.
ĺ
Clean the lint filters.
ĺ
Clean the plinth filter.
To switch off the message:
ĺ
Confirm with
OK
.
After a program has
been interrupted, the
following lights up:
Clean the lint and plinth
filter See
There is a build-up of fluff in the airways. See "Cleaning and
care" in the operating instructions.
ĺ
Clean the lint filters.
ĺ
Clean the plinth filter.
ĺ
Cleaning the air flow openings.
ĺ
Clean the heat exchanger.
To switch off the message:
ĺ
Switch the dryer off and then on again.
End/Cooling down
The program has finished but the laundry has not yet cooled
down.
ĺ
Either remove the laundry and spread it out to cool down
or leave it in the tumble dryer to cool down during the
cooling phase.
Problem/Fault message
Possible cause and solution
The display is in a dif-
ferent language
A different language has been selected in "Settings, Lan-
guage
".
ĺ
Set the language you want. The flag symbol will guide you.
The display remains
dark, and the Start/Stop
sensor button does not
light up or flash
There is no power to the dryer.
ĺ
Check whether the plug is plugged in.
ĺ
Check whether the fuse has tripped.
The dryer has switched off automatically to save energy.
ĺ
Turn the program selector to switch the dryer on again.
The laundry is not suffi-
ciently dry
The load consisted of different types of fabric.
ĺ
Finish drying using the
Time dry
drying program.
ĺ
Select a more suitable program next time.
Tip: You can alter the residual moisture level for some pro-
grams. See "Settings menu – Drying levels" in the operating
instructions.
Items made of synthetic
fibers are charged with
static electricity after
drying
Synthetic fibers tend to attract static charge.
Static charge can be reduced by adding a fabric softener to
the final rinse in the washing program.
There is a build-up of
lint
Lint is principally the result of friction when garments
are being worn and to some extent when they are being
washed. Machine drying hardly causes any lint to form.
Lint is collected by the
lint
and plinth filter and can be
removed easily.
See "Cleaning and care".
You can hear operating
noises (buzzing/hum-
ming)
This is not a fault. The compressor (heat pump) is operating
or you have selected the
SoftSteam
program.
No action required. These noises are quite normal and can
be heard when the compressor or the condensed water
pump is operating.
P
rogr
am
Load
(weight of dr
y laundr
y)
Laundr
y type
Extra dr
y
Normal
Slightly dry
Hand iron
Hand iron
Machine iron
Extr
a options
Normal
Full load (17.6 lb)
T-Shir
ts, under
wear
, baby clothes, workwear
,
jack
ets, covers, apr
ons, over
alls, hand t
owels,
bath t
owels, bathr
obes, bed linen
For T
-shir
ts, under
wear
, baby clothes: do not use
Extr
a dr
y
(laundr
y can shrink)
X
X
X
X
X
X
X
, , ,
W
rinkle-fr
ee
Half load (8.8 lb)
W
orkwear
, over
alls, pullovers, dr
esses, pants,
table linen, leggings
–
X
X
X
X
X
–
, , ,
Delicat
es
Small load (5.7 lb)
Dr
ess shir
ts, blouses, lingerie, appliquéd garments
–
X
X
X
X
X
–
, ,
Smoothing
Ver
y small load (2.2 lb)
Cott
on pants, jack
ets, shir
ts
–
–
X
X
–
–
, ,
W
oolens/Silks
Small load (4.4 lb)
P
ullovers, car
digans, socks, leggings
–
–
–
–
–
–
–
Dr
ess Shir
ts
Small load (4.4 lb)
Shir
ts, blouses
–
X
X
X
X
X
–
, , ,
MobileContr
ol
The Miele@mobile app is used t
o select the pr
ogr
ams and oper
at
e the appliance.
SoftS
team
Ver
y small load (2.2 lb)
Cott
on pants, jack
ets, shir
ts
–
–
X
–
X
–
–
,
Expr
ess
Half load (8.8 lb)
Resilient garments (such as those suitable for the
Normal
pr
ogr
am)
X
X
X
X
X
X
X
,
Denim
Small load (6.6 lb)
Pants, jack
ets, skir
ts, shir
ts
–
X
X
X
X
X
–
, , ,
Outdoor
Small load (5.5 lb)
Outdoor clothing
–
–
X
–
X
–
–
, ,
T
ime dr
y
Full load (17.6 lb)
Thick jack
ets, pillows, sleeping bags, blank
ets
–
–
–
–
–
–
–
, ,
Table Linen/
Dr
apes
Half load (8.8 lb)
Table linen, dr
apes, cur
tains
–
–
X
–
–
–
–
,
Cold Air
Full load (17.6 lb)
Ever
ything
–
–
–
–
–
–
–
P
roofing
Small load (5.5 lb)
Micr
ofiber fabrics, skiwear
, outdoor wear
, fine,
close weave cott
on garments (poplin), tablecloths
P
rohibit
ed: P
roofing agent containing par
affin
–
–
X
–
–
–
–
,
Bask
et pr
ogr
am
Maximum weight: 7.7 lb
Bags, shoes, stuffed animals, hats, scar
ves,
gloves, sequined t
ops
Only with dr
yer bask
et (optional accessor
y)
–
–
–
–
–
–
–
Spor
tswear
Small load (6.6 lb)
Spor
tswear
–
X
X
X
X
X
, ,
P
illows
–
P
illows (2 small or 1 lar
ge)
–
–
X
–
–
–
–
,
Bed linens
Half load (8.8 lb)
Bed linen
X
X
X
X
X
X
, , ,
= F
reshen up;
= Gentle;
= Anti-cr
ease;
= Buzz
er
X = yes, – = no
