Fitting the plinth facia
– The appliance plinth below the door
can be concealed using a plinth
facia.
– The height and return of the applian-
ce plinth cannot be altered.
– A taller plinth facia can only be instal-
led if the overall niche height is hig-
her.
Plinth height
Niche height
100 mm
(standard)
820 mm
–
150 mm
870 mm
a spacer
frame is
required
200 mm
920 mm
2 spacer
frames are
required
A plinth facia (60 cm long) can be orde-
red from your kitchen dealer or manu-
facturer.
A cut-out must be made in the
plinth facia around the ventilation
slots otherwise the air flow to the
appliance will be blocked and the
machine will not work.
Fitting the plinth facia:
Place the small template supplied on
the
back
of the upper edge of the
plinth facia and fasten with sticky
tape.
Cut out the plinth facia according to
the template.
Cover the cut surface with the strip
supplied.
Stick the velcro fastener supplied to
the appliance plinth.
For this the following procedure is re-
commended:
Press the two halves of the velcro fa-
stener together lengthwise.
Cut into 2 or 3 pieces.
Peel off the protective backing from
one half of the velcro fastener
pieces.
Stick the pieces along the appliance
plinth, at the left and right hand edge
and in the middle. Press firmly into
place.
Peel off the remaining protective
backing strips.
Press the plinth facia firmly onto the
sticky surface of the velcro.
Installation
33
Содержание T 659 C
Страница 39: ...39 ...