Electrical connection
Q\}
All electrical work should be under-
taken by a competent person in
strict accordance with national and
local safety regulations.
Connection of this appliance should be
made via a suitable isolator which com-
plies with national and local regula-
tions, and which is accessible after the
appliance has been built in.
The
voltage, rated load and fusing
are given on the data plate, located at
the rear of the appliance. Please en-
sure that these match the household
mains supply.
Please quote these data, and the
model and serial number when contact-
ing the Miele Service dept.
A second data plate is also supplied.
For extra safety it is advisable to install
a residual current device with a trip cur-
rent of 30 mA.
Control unit
Important U.K.
The appliance is supplied with a 3-core
cable for connection to a 230-240 volt
50 Hz supply.
The wires are coloured in accordance
with the following code:
Green/yellow
= earth
Blue
= neutral
Brown
= live
WARNING
THIS APPLIANCE MUST BE
EARTHED.
If the connection requires a different
cable, the Miele Service dept must
be consulted.
See the data plate for the maximum
rated load.
Possible combinations
The hob control units may only be com-
bined with one of the hobs listed below,
(not all units are available in every
country):
Hob
Hob electronic
control
KM 220
KM 221
KM 222
KM 230
KM 232
KSE 200
KM 240
KM 242
KM 243
KM 245
KM 246
KM 247
KM 248
KSE 202-1
KM 251
KSE 204-1
Electrical connection
Q\}
10
